Chapter 2 Printing
69
2.5 Setting the Pressure and Number of
Pinch Rollers to Use
• This setup applies to CJV200 models.
Set the pressure and number used to hold media based on the tool and media being used. Incorrect pinch
roller pressure settings may result in media skew or leave pinch roller marks on the media.
1
On the LOCAL mode screen, select [PR].
width:1340mm
PRTOOL
TEST CUT
LOCAL
2
Make settings based on the tool and media used.
• The following items can be configured:
• The settings are retained even when the power is turned off.
Item Setting Overview
Number for Use 160: 2–7
130: 2–6
75: 2–4
Sets the number of pinch rollers to use.
Print LOW/MID/HIGH Sets the pressure used for printing.
• Recommended value (normal): MID
Cut:Ends LOW/MID/HIGH Sets the pressure for both the pinch rollers on the edges
(left and right) used for cutting.
• Recommended value (normal): HIGH
Cut:Inner OFF/LOW/MID/HIGH Sets the pressure for the pinch rollers used for printing
other than those on the edges.
• Recommended value (normal): Low
Change Execution - Used to check settings. Switch to configured settings
before printing the built-in pattern (e.g., test printing, test
cutting).
Skip switching PR OFF/ON Enables or disables automatic pinch roller switching when
data is received. To change the pinch roller pressure, use
[Change Switching].
When the machine is not in use, raise the clamp lever to separate the pinch rollers from the grit
rollers.
• Leaving the pinch rollers lowered may cause them to become deformed and prevent media from
being fed correctly.
• Leaving media loaded will subject it to force from the pinch rollers, which may leave pinch roller
marks on it.
2
To Next Page
Loading...
