MIMAKI CJV200-160 - Adjust the Pinch Roller Positions

Chapter 2 Printing
50
2.3 Adjust the Pinch Roller Positions.
• This setup applies to CJV200 series models.
Adjust the pinch roller positions to suit the width of the media being used.
1
Choose the grit rollers capable of holding down the media at equal intervals.
Pinch roller
Grit roller
CJV200 shown here
2
Move the pinch rollers above the grit rollers.
• Use the pinch roller guide marks as references.
• When adjusting from the front
Pinch roller guide mark
Pinch roller unit (viewed from above)
Adjust so that the triangular mark lies between the two pinch roller guide marks.
• When adjusting from the rear
Pinch roller unit
3
Align the pinch rollers at both the ends to within 10 cm from the left edges and 2 cm from the
right edges of the media.
• Placement farther from the edges may leave some portions of the media uncut.
4
Manually set the pressure of the pinch rollers lying outside the media to "Low", and remove
the pinch rollers from the grit rollers.
• The pinch roller pressure is set to "Low" by moving the handle shown in the diagram below to left.
Handle
• Feeding media with the pinch rollers and grit rollers in contact will cause pinch roller wear.