Chapter 6 Maintenance
161
8
Close the waste ink tank stopper.
9
Press the [ENTER] key.
• The waste ink level will be reset.
Cutter for Cutting Machine (CJV200 Only)
Replace cutters when blades are chipped or blunt.
• Avoid touching the cutter blade. Failure to do so may result in injury.
• Do not shake the cutter holder. The cutter blade may come out.
l
Replacing Cutters
"Installing Cutting Tools"(P. 88)
Pen Line Replacement (CJV200 Only)
This machine can be used with the following pen lines.
• Pen line rubber
Used for pen writing or cutting
• Pen line sponge
Used for half cut (cutting across a dotted line)
• Turn off the main power and unplug the power cable before replacement.
1
Use tweezers to peel off the end of the pen line.
• Wipe off any adhesive remaining in the platen slot with industrial alcohol.
6
To Next Page
Loading...
