Chapter 7 Troubleshooting
183
Error
number
Message Cause Corrective action
2. Check to confirm nothing adheres to the
pen line rubber.
3. After installing the pen in a
commercially available pen holder,
check to confirm the installed position is
correct.
C63 Cutter Head • The cutter vertical
movement is slow.
• Turn off the main power and wait a
while before turning back on.
"Turning Off the Power"(P. 31)
d1b COM VOLT[1] • A problem was detected
with the main PCB
voltage.
b PCB MAIN-F* A fuse has blown on the main
PCB.
b5c Main PCB V05U A problem was detected with
the main PCB 5V power
supply.
b5d Main PCB V3R3U A problem was detected with
the main PCB 3.3V power
supply.
b5e Main PCB V1R5D A problem was detected with
the main PCB 1.5V power
supply.
b5f Main PCB V1R2U A problem was detected with
the main PCB 1.2V power
supply.
b60 Main PCB V24 A problem was detected with
the main PCB 24V power
supply.
*1. NCU is optional.
SYSTEM HALT
• If a SYSTEM HALT number is displayed, turn off the main power and wait a while before turning
back on.
7
To Next Page
Loading...
