Chapter 2 Printing
73
2.8 Head Cleaning
The following head cleaning methods are available. Choose the method based on test results. Cleaning is
not possible when the [Ink Near End] or [Ink End] errors are displayed. Replace with new ink. "Replacing
Ink"(P. 40)
Item Details
Soft If the print shows a bent line (Nozzle deflection)
Normal If the print shows a missing line (nozzle clogging)
Hard If soft cleaning and normal cleaning fail to resolve ejection failures (e.g., nozzle clogging
or deflection).
1
On the LOCAL mode screen, select [TEST PRINT/CLEANING] > [Cleaning], then press the
[ENTER] key.
• The Cleaning menu is displayed.
2
Select the cleaning type, then press the [ENTER] key.
3
Run another test print and check the print results.
• Repeat the cleaning and test printing process until the print results appear normal.
• Do the following if head cleaning fails to resolve the ejection failures (e.g., nozzle clogging
or deflection).
"Cap Rubber Cleaning"(P. 138)
"Print Head Nozzle Washing"(P. 167)
"Wiper Cleaning"(P. 140)
2
To Next Page
Loading...
