MIMAKI CJV200-160 - Spacing between Register Marks

Chapter 4 Cutting Data with Register Marks
106
Register mark size (A) Register mark length (B) Line width
501 to 1,000 mm 15 mm 1.0 mm
1,001 to 2,000 mm 25 mm
2,001 mm or more 35 mm
• If the "Fill around the registration marks" function of the RIP software is enabled, the register mark length
(B) should be 10 mm or more.
When Printing Register Marks Continuously
The register mark length (B) should be 8 mm or more. The machine may fail to detect register marks less
than 8 mm if it reads them continuously.
8 mm or more
Spacing Between Register Marks
The spacing between register marks (C) is as shown below.
(Mark shape) Type 1 (Mark shape) Type 2
Register mark length (B) x 2 + α, up to 1,000 mm
(C)
(B)
(B)
(C)
Register mark length (B) + α, up to 1,000 mm
(C)(B)
(B)(C)