Chapter 6 Maintenance
146
5
Clean both sides of the media cutter.
• Wipe off any adhesive paste, ink and dust adhering using a cleaning stick moistened with
industrial alcohol. Wipe off any industrial alcohol so that none remains.
6
Return the media cutter to its original position.
• Tighten the screw securely. A loose screw may cause cutter or platen damage.
7
Check the position of the media cutter.
• Lift up the media cutter by hand if it has dropped down.
8
Once cleaning is complete, close the cover, then press the [ENTER] key.
Media Holder Cleaning
Continuing to use a dirty media holder will prevent correct media detection or proper feeding of the media. It
will also cause dried ink and attached dust to rub against the head nozzle surface and lead to ejection
failures (e.g., nozzle clogging or deflection).
• Turn off the main power supply and unplug the power cable before carrying out maintenance.
To Next Page
Loading...
