MIMAKI CJV200-160 - Rear and Right Side View

Chapter 1 Before Use
23
Rear and Right Side View
1
2
4
5
8
9
6
7
3
No. Name Overview
1 Clamp lever Linked to the clamp lever at the front.
2 Media Sensor Detects whether media is present. "Media Sensor"(P. 25)
3 Preheater Preheats the media before printing to suppress rapid temperature change.
Adjust the temperature setting to suit the type of media used. "Setting
the Heater Temperature"(P. 70)
4 Feeding unit Compatible with 2-inch and 3-inch paper cores. "Loading the Roll
Media"(P. 59)
5 AC inlet The inlet at the rear (INLET1) is for the machine and the inlet at the front
(INLET2) is for the heater. Use the power cable provided. "Connecting
the Power Cable"(P. 30)
6 Main power switch The main power supply for the machine. To prevent ejection failures
attributable to the print head (e.g., nozzle clogging or deflection), do not turn
off the main power supply. "Power Supply Switch"(P. 26) "Turning
On the Power"(P. 30) "Turning Off the Power"(P. 31)
7 Heater power supply
switch
The power supply switch at the front is for the heater. Setting the Heater
Temperature
8 LAN port Connects to PC via a LAN cable. "Using a LAN Cable"(P. 33)
9 USB port Connects to PC via a USB interface cable. "Using a USB Cable"(P. 34)
1