MIMAKI CJV200-160 - Media Sensor Cleaning; Media Cutter Cleaning

Chapter 6 Maintenance
145
Media Sensor Cleaning
There is a media sensor located on the rear cover. The media cannot be detected correctly if dust or debris
accumulates on the sensors. Remove any debris using cotton swabs or a soft cloth.
Rear of product
Media Cutter Cleaning
Continuing to use a dirty media cutter may cause dust to collect on the head nozzle surface or the cutter
blade to grow dull.
• Avoid touching the cutter blade. Failure to do so may result in injury.
1
On the LOCAL mode screen, select [MENU] > [Maintenance], then press the [ENTER] key.
• The Maintenance menu is displayed.
2
Select [Station Maint.] > [Carriage Out] > [Move To Platen Right End], then press the [ENTER]
key.
• The carriage moves over the platen.
3
Open the maintenance cover (right side).
• The carriage can be moved by hand. Move the carriage slowly to a position allowing easy
access while working.
4
Remove the media cutter.
Screw
6