Chapter 6 Maintenance
149
1
On the LOCAL mode screen, select [MENU] > [Maintenance], then press the [ENTER] key.
• The Maintenance menu is displayed.
2
Select [Station Maint.] > [Custody Wash], then press the [ENTER] key.
• The carriage moves over the platen.
3
Open the maintenance cover (right side).
4
Clean the wiper.
• "Wiper Cleaning"(P. 140)
5
Clean the cap rubber.
• "Cap Rubber Cleaning"(P. 138)
6
Once cleaning is complete, press the [ENTER] key.
7
Fill the cap with maintenance liquid.
• Use a syringe to draw up some maintenance liquid and fill until it almost overflows from
the cap.
8
Close the maintenance cover (right side).
9
Set the exposure time, then press the [ENTER] key.
• Cleaning is performed automatically once print nozzle washing has ended.
• [Please wait] is displayed.
10
When [Maintenance liquid Fill the liquid.] appears again, open the maintenance cover (right
side), and fill the cap with cleaning solution as in step 7.
11
Close the maintenance cover (right side).
6
To Next Page
Loading...
