Maintaining the Capping Station
4-5
1
1
1
4
Routine Maintenance
5
Remove the wiper.
• Pull out the wiper by holding the protrusions at its both ends.
6
Clean the wiper and bracket.
• Wipe off the ink sticking to the wiper and bracket with a
clean stick dipped in cleaning liquid for maintenance.
Wipe off so that cleaning solution for maintenance will not
remain.
7
Set the wiper at the original position.
• Insert the wiper by holding both ends of the wiper.
8
Clean the wiper blade.
• Soak the clean stick in the maintenance cleaning liquid, and
then remove the ink that has adhered to the wiper blade.
• Clean the wiper and bracket until it looks as shown in
the photo on the right.
• After cleaning, make sure that the bracket and wiper
are aligned horizontally.
• Make sure to be careful with the edge of the
wiper blade, and thoroughly clean the side
(back side) where the wiper touches.
• Clean the wiper blade until it looks as shown
in the photo below.
To Next Page
Loading...
