4-6
9
Clean the cap rubber and cap rubber cover.
• Wipe off the ink sticking to the cap rubber and cap rubber
cover with a clean stick dipped in cleaning liquid for
maintenance.
Wipe off so that cleaning solution for maintenance will not
remain.
10
Press the key after the cleaning.
• After its initial operation, the machine returns to step1.
Performing the station maintenance without key
You can select station maintenance by using the key in the Local without pressing the key.
• Clean the cap rubber and cap rubber cover until it
looks as shown in the photo on the right.
• Make sure that the cap rubber and mesh inside the
cap have not come off after cleaning.
Press the
key in Local.
Press to
select [MAINTENANCE].
Press the key twice.
• It becomes the same condition as the
key is pressed from Local.
Cap rubber
Cap rubber
cover
To Next Page
Loading...
