-5.21-
5-1-14. Ink supply tube (inside diameter: ø2mm)
[Tools to be used]
• Phillips screwdriver (No.2 for M3 to M5)
[Disassembling procedure]
1) Turn ON the power of the device and then move the slider to the center of the platen using
the JOG key.
2) Turn OFF the power supply switch, remove the front cover, the Y cover and the head
cover.
3) Pull the ink damper for replaced tube from the head.
4) Loosen the screw and then send back the ink inside the tube to the cartridge.
5) Remove the screw (B3 x 6Bk) and then remove the bear cover L/R and remove the screw
for the ink supply tube ( ø2,ø3 ).
6) Pull the ink supply tube to replace from the cable bear and replace it.
[Assembling procedure]
• Assembly is reverse of disassembly.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
