-5.14-
5-1-9. Main FPC cable assy.
[Tools to be used]
• Phillips screwdriver (No.2 for M3 to M5)
• Phillips screwdriver (No.1 for M2)
[Disassembling procedure]
1) Turn ON the power of the device and then move the slider to the center of the platen using
the JOG key.
2) Turn OFF the power supply switch, remove the front cover, the Y cover.
3) Remove the screw (P3 x 6Bk) and then remove the head cover.
4) Remove the screw (P3 x 6SMW) and then remove the FPC cover. Pull out it from the
slider PCB.
5) Remove the electrical unit cover and then pull out the main FPC cable from HDC PCB.
(HDC : upside 5 , downside 2)
6) Remove the screw (P3 x 6SMW) and then remove the FPC ground board and the FPC
holder.
7) Remove the screw (P3 x 6SMW) to remove the FPC guide plate from the slider PCB BKT
and then remove the cable clamp.
8) Remove the main FPC cable assy. from the cable bearing.
9) Replace the main FPC cable assy.
[Assembling procedure]
• Assembly is reverse of disassembly.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
