– 5.12 –
5-1-8. Print head
[Tools to be used]
• Phillips screwdriver (No.2 for M3 to M5)
• Phillips screwdriver (No.1 for M2)
• Nippers (for removing SP)
• Box wrench (Bondhus type, opposite side distance: 2.5 mm, polarized)
• Small Phillips screwdriver (for removing Damper)
[Disassembling procedure]
1) Turn ON the power of the device and then enter the ID of the head to be replaced in
advance.
2) Fill up the ink to the head replaced.
3) Move the slider to the center of the platen using the JOG key.
4) Turn OFF the power supply switch, remove the front cover, the Y cover and the head
cover.
5) Remove the screw (P3 x 6SMW) and then remove the head cover BKT.
6) Remove the screw (P3 x 6SMW) and then remove the damper holder.
7) Remove the damper assy. of the print head to replace.
8) Remove the screw (P2 x 8SMW) from the print head assy. to replace.
9) Remove the screw (B3x 10Bk) from the angle spring and remove it.
9) Pull out the print head assy together with the damper holder to remove the FPC.
10) Replace the print head.
11) Fill up the ink.
12) Adjust the head position. (Refer to [6-6-2. Adjustment of the head] P.6-12)
[Assembling procedure]
• Assembly is reverse of disassembly.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
