MIMAKI JV4-180 User Manual

– 3.6 –
• The number of absent
ink cartridge is shown.
• The number of the ink
cartridge in which the
ink has run short.
• Ink has run out
• The number of times
of use of the wiper has
been exceeded.
•The ID numbers of
heads have not been
inputed.
• The clamp lever has
been lowered without
media placed.
• If roll paper is being
used, it indicates that
the media has run out.
1) Install the ink cartridge.
2) If the error recurs after the ink
cartridge has been installed.
Conduct sensor tests to find out the
cause of trouble.
Possible causes of the troubles are as
follows.
a) The cartridge presence/absence
sensor has failed.
b) Defective contact or disconnection
of relay cables.
c) Ink sensor PCB has failed.
d) Main PCB has failed.
1) Replace the ink cartridge with a new
one.
2) If the error recurs after the ink
cartridge has been replaced, conduct
sensor tests to find out a possible
cause of the trouble.
Possible causes of the troubles are as
follows:
a) The ink end sensor has failed.
b) Defective contact or disconnection
of relay cables.
c) Ink sensor PCB has failed.
d) The main PCB has failed.
1) Replace the ink cartridge with a new
one.
1) Replace the wiper.
1) Input the ID numbers of heads.
1) Place media first, then lower the
clamp lever.
2) If the error occurs with media loaded
on the machine, conduct sensor tests
to find out a possible cause of the
trouble.
Possible causes of the trouble are as
follows:
a) The sheet sensor has failed.
b) The IO PCB has failed.
c) The main PCB has failed.
3-2-2. Ink-related components and other components
Message Description
Corrective measures and
recovering procedures
<LOCAL> CARTRIDGE
K
<LOCAL> INK near END
K
<LOCAL> INK END
KC Y
<<LOCAL>>
REPLACE WIPER
<<LOCAL>>
HEAD ID ?
<<LOCAL>>
NO MEDIA
Downloaded From ManualsPrinter.com Manuals

MIMAKI JV4-180 Specifications

General

Brand	MIMAKI
Model	JV4-180
Category	Printer
Language	English