– 3.5 –
1) Make sure that there is no
gap between platen F
(aluminum) and the edge
of the P cover F rubber. If
there is a gap, stick the
rubber appressed against
the platen. The gap may
be detected in mistake.
2) Make sure that platen
cover F is fixed securely
using the platen cover F
mounting screws (attached
on auxiliary side plates R
and L to prevent the cover
from protruding).
3) Check if the media right
edge is set at a position
15mm or more from the
rightmost edge of the
rightmost feed roller:R1
toward the station side or
not.
4) Cleaning or replace a
paper width sensor.
5) Replace a main FPC
cable.
6) Replace a slider PCB.
7) Replace a HDC-4Head
PCB.
8) Replace a main PCB.
1) Replace a Y axis motor.
2) Replace a Y origin sensor.
3) Replace a IO PCB.
4) Replace a main PCB.
• Media detection has not been
successfully carried out.
• Y-axis origin detection has
not been successfully carried
out.
ERROR50 MEDIA SENSE
ERROR51 Y ORIGIN
Error message Cause Corrective measure
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
