ā 6.8 ā
3) Press the
key to enter the flashing mode.
Set Shot to 5000000 (maximum value) and then press the
key. Flashing operation
is performed on the Cap automatically.
4) Press the plain paper with your hand to make a mark of the Cap and then remove it.
If the gap between the Cap and flashing is 0.5mm or more, the result is OK; otherwise, re-
adjust the forward and backward position of the Cap.
0.5mm or more
0.5mm or more
1. Return the head
to on cap.
2. Flashing 3. Move the head
on platen.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
