Special Imaging Modes
11-3
11.1.1.2 Basic Procedures for 3D Imaging
Basic procedures for 3D imaging are as follows:
1. Select the proper exam mode.
2. Optimizing the 2D image.
3. Enter Smart 3D mode.
4. Set ROI (Region of Interest).
5. Capturing 3D images.
6. Setting VOI (Volume of Interest).
7. 3D browsing and parameter adjusting.
8. Adding comment or body mark to an image (the operation for 3D image is the same
to the image in other modes).
9. Image saving.
11.1.2 Smart3D Presetting
11.1.2.1 Shortcut Key Preset
You can preset a user-defined shortcut key for entering Smart 3D through the path:
<Setup>-[System Preset]-[Key Config]. For details, please refer to “17.2 System Preset”.
11.1.2.2 Parameter Preset
1. Enter the [Preset] menu, select [Image Preset].
2. Select [Smart3D] tab.
3. Preset the 3D parameters according to your preferences, or remain the factory
settings. [Image Preset] page is shown in the following figure.
To Next Page
Loading...
Need help?
General
