22-1
22 System Maintenance
Routine system maintenance shall be completed by the user. Service maintenance will be
provided by Mindray service engineers while the system is under warranty. System
maintenance after the warranty has expired is the full responsibility of the owner /
operator.
WARNING:
1. Only an authorized Mindray service engineer can perform
maintenance not specified in this operator’s manual.
2. For the sake of the system performance and safety, you
should perform periodical checks for the system.
22.1 Daily Maintenance
You are responsible for daily maintenance.
22.1.1 Cleaning the System
WARNING:
Before cleaning the system, be sure to turn off the power
and disconnect the power cord from the outlet. If you clean
the system while the power is On, it may result in electric
shock.
îš„ Cleaning a transducer
Please refer to the operator’s manual of the corresponding transducer to perform
cleaning and disinfection.
îš„ Cleaning the transducer cable
a) Use soft dry cloth to wipe off stains from the transducer cable.
b) If it is difficult to clean the stains thoroughly, use soft cloth dipped with mild
detergent, and then let the cable air dry.
îš„ Cleaning the monitor
Using a soft cloth, apply little clean water or soapy water directly to the cloth and wipe
down the monitor to remove finger marks, dust and smudges. Allow the monitor to air-dry.
NOTE: Do not use hydrocarbon little clean water or soapy water or cleaner for OA
(Office Automation) equipment to clean the monitor. These substances may
cause deterioration of the monitor.
To Next Page
Loading...
Need help?
General
