Set-up & Connections
5-9
Please refer to the accompanying manuals of the printers for more details.
5.12 Use of M-Pack
5.12.1 Introduction of M-Pack
M-Pack is a portable pack, which is used when you carry it on your shoulders to hold the
system and simultaneously operate the system.
NOTE: 1 When using M-Pack, you shall avoid operating and walking at the same time
to prevent tumble caused by blocked line of sight or distraction.
2 When using M-Pack, mind your sense of balance and prevent falling over.
3 You can use M-Pack inside or outside the room; however, if you want to place
the system on a table to operate, you shall take the system out of the pack.
4 Before using the M-Pack, you must carefully check all components of it;
especially check that snap rings and slings are sturdy and free from being
worn-out.
5 Do not operate the system inside M-Pack for more than one hour; otherwise it
may result in overheating.
Before using the M-Pack, make sure that air vents of the system and M-Pack
are not blocked.
6 You must clean the transducer before placing it inside the pack in order to
prevent it from staining the pack.
7 When using M-Pack, if you feel tired because of long period of operation,
please stop operating in order to prevent misoperation.
USB cable
Power cord
To Next Page
Loading...
