Parameter Setup
17-5
17.4 Image Parameter Preset
Refer to “10.4 Image Parameter Preset”.
17.5 Comment Preset
Refer to “14.7 Comment Preset”.
17.6 Body Mark Preset
Refer to “15.8 Body Mark Preset”.
17.7 Measurement Preset
Refer to Measurement Preset in the Operator’s Manual [Advanced Volume].
17.8 Soft-key and Menu Preset
You can preset parameter items in image modes for all types of transducers, in the menu
(displayed at the bottom of the screen) and the menu (displayed on the upper left side of
the screen), as well as parameter items for 3D capture, 3D review, PW mark, Reset ROI.
In addition, you can preset parameter items in freeze status and cine review status.
Open the [Soft-key and Menu Preset] screen
To open the [Soft-key and Menu Preset] screen, press [Setup] and select Key and Menu
Preset. The default is the currently-used transducer in the current image mode.
Preset Operations
Since the preset operations are the same for different image modes and statuses, the
following case (linear transducers in real time B mode) is taken as an example.
1. Parameter Items Displayed in Soft Menu
The system has factory settings for parameter items displayed in soft menu; however, you
can preset or customize them according to your preferences.
To preset parameter items in soft menu, enter [Image Params] page in the [Key and Menu
Preset] screen, select Probe Type as Linear and select Image Mode as B. Open the
[Softkey] page on the right side. See the figure below.
To Next Page
Loading...
Need help?
General
