Mindray M5

Parameter Setup
17-7
2) Click [Down]
3) The item will move down, and the item below it will move up.
2. Parameter Items Displayed in Image Menu
To preset parameter items in image menu, enter [Image Params] page in the [Key and
Menu Preset] screen, select Probe Type as Linear and select Image Mode as B. Open
the Menu page on the right side. See the figure below.
 Add or delete an item
To add an item to the image menu, select an item in the Available Items box and click .
This item will display in the image menu.
To delete an item from the image menu, select an item on the right side box and click
.
This item will disappear from the image menu.
To delete all items from the image menu, directly click
. All items will disappear from
the image menu.
 Change position of an item
To change position of an item, select the item in the right side box and click [Move Up] or
[Move Down].
 Exit the [Soft-key and Menu Preset] screen
Click [OK] to confirm the preset operations and exit the screen;
Click [Cancel] to cancel the preset operations and exit the screen.