Image Modes
10-10
B/C Wide
Set and constrain the maximum width of the B Mode image to that of the Color RoI.
z Click [B/C Wide] item in the menu.
z Select [On] or [Off] to turn on / off the feature.
Scale
The Scale feature is used to adjust speed scale and change PRF.
z
Click [Scale] item in the menu.
z Increase or decrease its value.
Baseline
To adjust the Color Mode Baseline to change the range of flow speed:
z
Click [Baseline] in the menu.
z Increase or decrease its value.
Dual Live
Dual Live allows B mode and Color mode to be active at the same time.
z Click [Dual Live] item in the menu.
z Select [On] or [Off] for Dual Live to turn on or off B and Color alive at the same
time.
Acoustic Power
The acoustic power refers to ultrasound power transmitted from the transducer. You should
perform exams according to actual situation and ALARA Principle.
z
Click [A. Power] item in the menu to select among percentages.
z The AP value is also displayed at the top of the screen.
B Image Display
z
Click [B Image Display] item in the menu.
z Select [On] or [Off] to turn on or off the B Mode image display as live Color remains
active.
2. Optimizing Color Images
Color gain
z Rotate the [iTouch] key located on the right side of the control panel.
z The gain value is displayed on the image parameter area.
Flow State
z
Click [Flow State] item in the menu.
z Select [Flow State] among L, M and H.
Steer
The Steer feature is used to adjust the RoI of color flow with different angles but with
immobility of the linear transducer.
z
Click [Steer] item in the menu.
z Change the value.
z This feature is valid only for linear transducers.
Invert
The color bar can automatically invert when the color flow is steered to a certain angle, thus
accommodating operator’s habit of distinguishing flow direction. However, you can also invert
the color bar manually.
To invert the color bar automatically, you need to set it up beforehand.
z
Press [Setup] key to show the [Setup] menu.
z Click [System] item to open the [System] screen.
z Click [Image Preset] tab to open [Image Preset] page.
z Check [Auto Invert] item in the [Image] region.
To Next Page
Loading...
Need help?
General
