148
The new Loop Controller will be added alongside any existing controllers under the
currently selected network node.
Some models may have a fixed number of addressable and conventional loop controllers, in
which case this Insert Menu item will be disabled.
Add Annunciator
This command will display the Add Annunciator dialog where you can specify the type and
number of annunciators to add to your job.
For a network job, the new annunciator will be added to the currently selected Node. For
non-network the new annunciators will be added alongside any existing annunciators.
Add Display Adder
This command will display the Add Display Adder dialog where you can specify the type and
number of adders to add to the currently selected annunciator or main display.
Display Adder is only enabled when a target Annunciator can be uniquely identified. This
means that an Annunciator or one of its Display Adders must be selected in the job tree.
Add Item
Depending on what is currently selected in the job tree, one of the following add commands
can appear in the insert menu.
Add Device - if a Dev Loop is being displayed.
Add Amplifier - if an Amplifiers loop of an audio controller is being displayed.
Add Zone - If the selected tree item is the Input Zones branch of a CPU (QLA or Base I/O of
a Master), add a zone.
Add Message - If the selected tree item is the Custom Messages branch of a remote
annunciator, add a Message.
Add Group - If the selected tree item is Output Groups branch of a CPU (QLA or Base I/O of
a Master), add a group.
Add Device
If you select Add Device from the Insert Menu then one of these dialogs will be displayed,
depending on the loop type.
To Next Page
Loading...
Need help?
General
