45
Audio Setup
This dialog is displayed in response to clicking the Setup button in the Audio section of the
Job Details page.
Alert and Evac state options – press the ... (ellipsis) button to launch the Manage Message
Dialog to select which audio tone or digitized message to broadcast when the system
reaches that state. You can select an existing message or create a new one. On return the
selected message is assigned to the chosen Alert or Evac state.
As per UL 864 and UL 2572 only Built-in tones or custom tones that are verified to have the
standard-specific duration are permissible.
Manage Messages... - also launches the Manage Message Dialog allowing you to add,
delete or edit messages. These messages then become available for use here (for Alert, Evac,
etc.) or to be assigned to a Digitized Message switch.
Sound pre-announce tone when paging – when enabled, a 900Hz pre-announce tone is
sounded for 2 seconds before the paging audio source is applied. This special tone will un-
silence speakers that are currently silenced.
To Next Page
Loading...
Need help?
General
