136
Fire Phone Configuration
Introduction
The configurator allows the user to set up an Audio Controller, conventional phones,
addressable phones, remote field phones, master telephone handsets and telephone
selectors, and connect them together.
There must be at least an Audio Controller, a Telephone Master Controller (QMT-5302N)
and Telephone/Page Selector (QZP-5101). The Audio Controller supports conventional fire
phone circuits or addressable fire phone circuit, which also require addressable fire phone
modules. If you configure addressable fire phone modules you must also ensure that there
is an addressable line to support them.
Adding Audio Controller
This can be done by shifting the focus on the job tree to the network node where you wish
to add the Audio Controller and:
• By pressing the right mouse button and choosing Add Audio Controller from the
pop up menu;
• By using the Insert menu and choosing Add Audio Controller.
The new Audio Controller appears in the job tree. Its CPU Number is initially set to the next
available address. Below it, looking very much like loops of a loop controller, are two more
items: Phone Lines and Amplifiers.
You must also specify whether the four or five lines are to be configured as conventional
phones or as addressable phone lines to serve addressable phone modules. After the Audio
Controller is added you can still edit these attributes, or change just some of the lines
between addressable and conventional.
Adding Fire Phone Module
Invoke Add Device function. This can be done...
• By pressing the right mouse button, with focus on an addressable device list.
• By using the Insert menu and choosing Add Device.
To Next Page
Loading...
Need help?
General
