137
The following dialog appears.
Device: set this to Firephone Module.
SubType: the only available option is "None"
Address: specify the address for the new device. This defaults to the lowest available
address.
Number to add: You can specify how many devices to add by changing this value. The
configurator will attempt to allocate the devices sequentially, starting with the address you
selected. If there are insufficient sequential addresses you will be shown a message with
three options. “Yes” tells the configurator to continue adding devices, starting at the next
available address and continuing to do so each time it runs out of sequential addresses.
“No” tells it to add as many as will fit and stop. “Cancel” tells it to stop without adding any
devices.
Click Add to continue.
After the operation is complete the dialog remains open for re-use. The Address value is
adjusted to account for the devices just added.
If at any time during the transaction there are no more available addresses, the entire
transaction is rolled back. No devices will have been added.
If there are no available addresses for the chosen Type then the Add button is disabled. You
can select another type, or close the dialog.
The Close button dismisses the dialog.
To Next Page
Loading...
Need help?
General
