17
Adder Type – Select the type of Circuit Adder to add, from the drop down list of those
available on your system.
The FleX-Net™ system supports 3 types:
• 8 Input Adder - 8 Ckts:
Will add additional DM-1008A Input Module with 8 Class B (4 Class A) Input
Circuits.
• Supv Opt. Adder - 4 Ckts:
Will add a SGM-1004A Signal Module with 4 Supervised Output Circuits.
• Relay Opt. Adder - 8 ckts:
Will add RM-1008A Relay module with 8 Relay circuits.
After the operation is complete the dialog remains open for re-use.
Close - Press to dismiss the dialog.
Note: Some products have a fixed number of conventional circuits and the user cannot
delete them or add more.
Examples:
Add 8 Input Adder - 8 Ckts:
Will add additional DM-1008A Input Module with 8 Class B (4 Class A) Input Circuits
Add Supv Opt.adder 4 Ckts:
Will add a SGM-1004A Signal Module with 4 Supervised Output Circuits
Add Cntct Opt - 8 ckts:
Will add RM-1008A Relay module with 8 Relay circuits.
Custom Sub Types
There are 16 Custom SubTypes for each circuit. Each circuit can have a custom subtype
assigned which then can be exported to OpenGN. In OpenGN when events in the system
are reported, it shows the custom subtypes assigned instead of just the device types.
Custom Sub Types are used only for OpenGN reports. For example, input module, it can
have Manual Station, Monitor Input, Flow Switch, Low Pressure, Low Temperature, etc...
To Next Page
Loading...
Need help?
General
