91
Input Circuit Correlations
If the currently selected circuit(s) is/are inputs then the correlation view has a tab for Input
Zones only. Input Circuits must be combined into input zones before they can be correlated
to outputs or LEDs, etc. Input Circuits can only be correlated to Input Zones of a matching
type (e.g. Alarm, Trouble, etc.).
Add Correlations
When the user selects Add Correlations a non-modal dialog is used to display the circuits
and display items that are eligible to be correlated to the selected items in the top, right
pane. It has the same set of tabs as the correlation view. It is kept synchronized with the
correlation view: if a certain tab category is selected on one, its counterpart is automatically
selected on the other. As correlations are added to the current set, they are removed from
the available set.
If multiple items are selected in the top pane, then the correlations view will only show
those correlations that are common to all of them. This means the set of displayed
correlations can shrink to the empty set. If the user selects a mix of input and outputs no
correlations can be shown.
Input Zone Correlations
If the currently selected object is an Input Zone then the correlations view has tabs for:
• Inputs
• Signal
• Relay
• Custom Message Tags
• Display
• Switches
• UDACT Grp
• Digitized Msgs
• Advanced Logic
To Next Page
Loading...
Need help?
General
