Mitsubishi M80 series User Manual

M800S/M80/E80 Series Connection and Setup Manual
13 Connection of MITSUBISHI CNC Machine Operation Panel
337
IB-1501269-J
(2) Sub panel
Sub panel is equipped with cutting override, rapid traverse override, memory protection switch and emergency stop
switch. Direct wiring is available for the emergency stop switch, and device numbers for the other switches are
assigned as listed below:
(a) Cutting override (6bit)
(b) Rapid traverse override (6bit)
(c) Memory protection switch (1bit)
(Note 1) "$" in the device No. varies depending on the channel No. of RIO.
(RIO1 = "0", RIO2 = "2", RIO3 = "4")
Setting
value
Device
ZR5$22[0] ZR5$22[1] ZR5$22[2] ZR5$22[3] ZR5$22[4] ZR5$22[5]
0 000000
10 100001
20 110000
30 010001
40 011000
50 111001
60 101000
70 001001
80 001100
90 101101
100 111100
110 011101
120 010100
130 110101
140 100100
150 000101
160 000110
170 100111
180 110110
190 010111
200 011110
Setting
value
Device
ZR5$22[6] ZR5$22[7] ZR5$22[8] ZR5$22[9] ZR5$22[A] ZR5$22[B]
0 000000
10 100001
20 110000
30 010001
40 011000
50 111001
60 101000
70 001001
80 001100
90 101101
100 111100
Setting
value
Device
ZR5$23[2]
LOCK 0
ENABLE 1

Mitsubishi M80 series Specifications

General

Type	CNC Control Unit
Power Supply	24V DC
Interpolation	Linear, circular, helical
Fieldbus	CC-Link
Operating Temperature	0 to 45°C
Interface	USB, RS-232
Processor	RISC processor
Ethernet	Yes (100BASE-TX/10BASE-T)