4 - 10
Chapter 4 Installation, Wiring and Maintenance of the Produc
CAUTION
If the adhesion of solvent and oil to the cord part of SSCNET cable may lower the optical
characteristic and machine characteristic. If it is used such an environment, be sure to do the
protection measures to the cord part.
When keeping the QD77MS or servo amplifier, be sure to put on a cap to connector part so that
a dirt should not adhere to the end of SSCNET
connector.
SSCNET connector to connect the SSCNET cable is put a cap to protect light device inside
connector from dust. For this reason, do not remove a cap until just before connecting
SSCNET
cable. Then, when removing SSCNET cable, make sure to put a cap.
Keep the cap and the tube for protecting light cord end of SSCNET cable in a plastic bag with
a zipper of SSCNET
cable to prevent them from becoming dirty.
When exchanging the QD77MS or servo amplifier, make sure to put cap on SSCNET
connector. When asking repair of QD77MS or servo amplifier for some troubles, make also sure
to put a cap on SSCNET
connector. When the connector is not put a cap, the light device
may be damaged at the transit. In this case, exchange and repair of light device is required.
To Next Page
Loading...
