5 - 162
Chapter 5 Data Used for Positioning Control
Setting item Setting details
Cd.7
M code OFF request
•
The M code ON signal turns OFF.
Fetch cycle: Operation cycle
Cd.8
External command valid
•
Validates or invalidates external command signals.
Fetch cycle: At request by external command signal
•
When changing the "current feed value" using the start No. "9003", use this data
item to specify a new feed value.
•
Set a value within the following range:
Pr.1
Unit
setting
mm
(
10
-1
µm)
inch
(
10
-5
inch)
degree
(
10
-5
degree)
PLS
(PLS)
Setting range
-2147483648
to
+2147483647
-2147483648
to
+2147483647
0 to 35999999
-2147483648
to
+2147483647
Cd.9
New current value
Fetch cycle: At change request
•
When changing the acceleration time during a speed change, use this data item
to specify a new acceleration time.
Cd.10
setting range (unit)
0 to 8388608 (ms)
Cd.10
New acceleration time value
Fetch cycle: At change request
•
When changing the deceleration time during a speed change, use this data item
to specify a new deceleration time.
Cd.11
setting range (unit)
0 to 8388608 (ms)
Cd.11
New deceleration time value
Fetch cycle: At change request
To Next Page
Loading...
Need help?
General
