Moeller DF51 - Page 225

10/05 AWB8230-1541GB
Table for user-defined
parameter settings
221
A095
––
Acceleration time, frequency for
changeover from ramp time 1
to ramp time 2
0.0 – 400 Hz 0.0 93
A295
––
Acceleration time, frequency for
changeover from ramp time 1
to ramp time 2
(second parameter set)
0.0 – 400 Hz 0.0 93
A096
––
Deceleration time, frequency
for changeover from ramp time
1 to ramp time 2
0.0 – 400 Hz 0.0 94
A296
––
Deceleration time, frequency
for changeover from ramp time
1 to ramp time 2
(second parameter set)
0.0 – 400 Hz 0.0 94
A097
––
Acceleration time,
characteristic
00: linear 00 74
01: S curve
A098
––
Deceleration time,
characteristic
00: linear 00 74
01: S curve
A101
–
j Analog input (OI-L), frequency
at minimum reference value
0 – 400 Hz 0.0 90
A102
–
j Analog input (OI-L), frequency
at maximum reference value
0 – 400 Hz 0.0 90
A103
–
j Analog input (OI-L), minimum
reference value (offset)
0 – 100 % 0. 90
A104
–
j Analog input (OI-L), maximum
reference value (offset)
0 – 100 % 100. 90
A105
–
j Analog input (OI-L), selection of
starting frequency applied to
the motor at minimum
reference value
00: Value from PNU A101 01 90
01: 0 Hz
A141
–
j Calculator – select input A 00: Keypad value 02 127
01: Potentiometer of keypad
02: Analog input (O)
03: Analog input (OI)
04: Serial interface (Modbus)
A142
–
j Calculator – select input B Values a PNU A141 03 127
A143
–
j Calculator – operation 00: Addition (A + B) 00 127
01: Subtraction (A – B)
02: Multiplication (A x B)
A145 jjCalculator – offset frequency 0 – 400 Hz 0.0 128
A146
–
j Calculator – offset frequency,
prefix
Value from PNU A145 00 128
00: plus
01: minus
A151
–
j Potentiometer (keypad),
starting frequency
0 – 400 Hz 0.0 92
A152
–
j Potentiometer (keypad), end
frequency
0 – 400 Hz 0.0 92
PNU RUN b031
= 10
Name Value range DS page User setting