Device Description MV4-150-TA1, MV4-450-TA1, MV4-170-TA1, MV4-470-TA1 1-7
Moeller 07/01 AWB-C2700-1347GB
4 Device mounting
4.1 General mounting instructions
The Touch Operator Panels are suitable for installation in an enclosure which is closed from the rear. The
unit is installed directly from the front with four countersunk screws (standard version), or from the rear using
threaded bolts and nuts (stainless steel version).
After mounting the rear of the units must be accessible (Download button, see Section 9).
The mounting version allows protection in compliance with IP 65 (see Section 5.1).
The Touch Operator Panel can be operated at an ambient temperature of up to 50 °C (see Section 17). The
ambient temperature refers to the area directly in the vicinity of the lower cooling slits of a vertically mounted
device provided with unhindered air convection and mounted at a location no more than 2000 m above sea
level. The cooling slits must always be kept clear to ensure the proper cooling of the system.
Mounting inside an enclosure is possible provided that the permissible ambient temperature is observed. A
clearance of at least 30 mm from all sides of the enclosure must be observed in order to ensure sufficient air
circulation.
Avoid exposing the flat screen to direct sunlight. The radiation from the sun (UV component) reduces the
lifespan of the LCD display.
The cooling slits must be kept clear to ensure the proper cooling of the system.
Avoid exposing the flat screen to direct sunlight.
After mounting the rear of the device must be accessible (Download button).
To Next Page
Loading...