Device Description MV4-670-TA1/2, MV4-690-TA1/2 3-12
Moeller 07/01 AWB-C2700-1347GB
5 Mounting Instructions
5.1 Installation according to degree of protection IP65
Mounting should be carried out with particular care in order to ensure correct sealing in compliance with IP65
protection.
1. Position the front seal from the rear over the MV4-600 and place it on the front plate.
2. Insert the device from the front into the cutout in the enclosure or cabinet.
3. The front seal must be level and evenly positioned between the front plate and the front panel.
4. The nuts must be tightened evenly and securely..
5. Check that the front seal is positioned correctly and that an even pressure is applied to it.
Observe the general mounting instructions (→ Section 4.1).
To Next Page
Loading...