Moeller MV4 Series - Jetter

Communications Card Description ZB4-601-IF1, ZB4-609-IF1 4-36
Moeller 07/01 AWB-C2700-1347GB
8.13 Jetter
JETTER
PLC Type Protocol PLC Port Parameters
PASE
SYMPAS Viadukt Port 9600 baud, 8 data bits, 1 stop bit, no parity
DRIVER DESIGNATION (10, 5) : OTHERS > PASE (MPB.BIN)
SUPPORTED DATA TYPES : R
WIRING LIST
RS 232
Signal Pin Pin Signal
RxD 2 2 TxD
TxD 3 3 RxD
SG 5 7 SG
ZB4-601/609-IF1 Viaduct-port
(9 pole male) (9 pole male)
Note the poles since the two devices are
connected with the same D-Sub
connectors and the assignment is not
identical.
NOTES
• The ZB4-601/609-IF1 is connected to the PASE via the Viaduct Port using the PG protocol and requires
specific parameters to be set.
• The registers “R” are divided into 1):
1R Range REG 00001...01996/16 Bit Access
2R Range REG 00001...01996/24 Bit Access
3R Range REG 50001...01996/16 Bit Access
4R Range REG 50001...01996/24 Bit Access
• 1) Read next section SPECIAL NOTE (without fail!)