Communications Card Description ZB4-601-IF1, ZB4-609-IF1 4-17
Moeller 07/01 AWB-C2700-1347GB
SIEMENS
PLC Type Protocol PLC Port Parameters
S5
AS511 PG-Port 9600 baud, 8 data bits, 1 stop bit, parity even
DRIVER DESIGNATION (3, 2) : SIEMENS > AS511 (MPB.BIN)
SUPPORTED DATA TYPES : DW
WIRING LIST
TTY
Signal Pin Pin Signal
IN 1 6 OUT+
SG 5 7 OUT-
9IN+
OUT 9 2 IN-
ZB4-601/609-IF1 S5 PG
(9 pole male)
(15 pole male)
NOTES
• The interface to the PG-Port of the S5 is the same as for the programming device. No parameter settings
or function blocks are required.
• With CPUs that have two interfaces it is best to use the second one since usually not all PG functions are
available on this. All the functions of the ZB4-601/609-IF1 can be implemented with this port.
• The PLC must be in Run status for active communication.
• If both data blocks or data words are addressed that are not available in the PLC, this will cause errors in
the communication.
To Next Page
Loading...