Communications Card Description ZB4-601-IF1, ZB4-609-IF1 4-46
Moeller 07/01 AWB-C2700-1347GB
8.18 Selectron
SELECTRON
PLC Type Protocol PLC Port Parameter
SELECONTROL
MAS
Modbus RTU X2/RS 232 9600 baud, 8 data bits, 1 stop bit, even parity
DRIVER DESIGNATION (11, 1) : BUS > MB RTU1 (MPB.BIN)
SUPPORTED DATA TYPES : R, M
WIRING LIST
RS 232 (CPU751/752) RS 232 (CPU714/715)
Signal Pin Pin Signal
RxD 2 3 TxD
TxD 3 2 RxD
SG 5 5 SG
ZB4-601/609-IF1 X2 RS 232
(9 pole male)
(9 pole female)
Signal Pin Pin Signal
RxD 2 TxD
TxD 3 RxD
SG 5 SG
ZB4-601/609-IF1 RS 232
(9 pole male)
(Screw Terminal)
NOTES
• The appropriate driver from the COM_SIO_ULib must be loaded into the SELECONTROL MAS in order
to exchange data with it on the Modbus RTU protocol.
Order no. of the COM_SIO_ULib : 421.0604
• Refer to the relevant documentation from the supplementary manual “CAP1131 User Library” for
information on loading and configuring the driver.
Ensure that interface parameters match those specified (even parity)
• The version of the Modbus RTU driver in the SELECONTROL MAS must be higher or equal to 2.01.
• The ZB4-601/609-IF1 operates as master.
The station number set on the ZB4-601/609-IF1 must match the one output for the driver in the PLC.
• Two different Read/Write data types are available:
“R” are word registers and correspond to the “wOR” data cells in the PLC
“M” are bit registers and correspond to the “xOD” data cells in the PLC
ZB4-601/609-IF1 SELECONTROL MAS
R1...256 wOR[0...255]
M1...256 xOD[0...255]
All other data types supported by the Selecontrol driver are not used.
The ZB4-601/609-IF1 can process considerably larger data addresses (R1...R9996 and M1...M9996).
This is also possible in the PLC with small modifications of the driver. If necessary ask the manufacturer
of the PLC driver.
To Next Page
Loading...