Device Description MV4-670-TA1/2, MV4-690-TA1/2 3-7
Moeller 07/01 AWB-C2700-1347GB
4 Device Mounting
4.1 General mounting instructions
The installation of MV4-600 series devices occurs using threaded bolts. Accessibility to the rear side of the
device must be guaranteed. The devices is installed from the rear using washers and nuts.
All mounting versions ensure a sealed mounting to IP65. The relevant mounting instructions must be
observed (→ Section 5).
Ensure that the mounting allows access to connections, status LEDs, operating elements, such as the
Download button and the memory card (PC card). Ensure sufficient space for outgoing cables (connector
housings and bending radii of cables).
The MV4-600 units can be run at a maximum ambient temperature of 50°C (→ Section 21). The ambient
temperature refers to the air temperature in the vicinity of the lower cooling slots, with vertical mounting,
unobstructed air convection and a maximum operating altitude of 2000m above sea level. When mounting in
an enclosure or cabinet, the ambient temperature is likewise the air temperature inside the enclosure
concerned. In this case it is assumed that the air temperature at the front of the device is not higher than the
temperature in the enclosure or cabinet, and there is no additional heat caused by radiation or conduction
that has an effect on the device.
The cooling slots must always be free in order to ensure the proper cooling of the system. Ensure a wall
clearance of at least 3 cm on all sides of the housing, so that proper air circulation is not impaired.
Avoid exposure to direct sunlight on the flat screen, even when it is switched off. The sunlight
(UV component) and the resulting heat may damage the display.
The cooling slots must always be free in order to ensure the proper cooling of the
system.
Avoid the exposure of the flat screen to direct sunlight.
Ensure that operating elements (Download button, memory card) and connections are
still accessible when the device is mounted.
To Next Page
Loading...