Moeller MV4 Series - System Port (Function, Assignment); 8 Memory Card Slot

Device Description MV4-570-TA1/2, MV4-590-TA1/2 2-15
Moeller 07/01 AWB-C2700-1347GB
SYSTEM PORT
D-Sub 9 Pol male
Pin No Assignment
1 DCD
2RxD
3TxD
4DTR
5Gnd
6DSR
7RTS
8CTS
9RI (+5 V)
Case Shield
7.3 System Port (Function, Assignment)
Use the System Port to
• load project data to the memory card of the Touch Operator Panels (Download, serial link with the host
PC), as an alternative to loading project data to the memory card on the PC
• connect a serial printer for report printouts from the application
• communicate via the SUCOM-A protocol (from MV4 Configurator, V 3.03).
For SUCOM-A communication select the PLC type “Moeller... PRG” (COM) in the
MV4 Configurator. The required SUCOM-A cables ZB4-237-KB1 (for PS4) and
ZB4-233-KB1 (for PS416) must be used with an adapter (9-pol. SUB-D female
connector to 9-pole SUB-D female connector).. This can be ordered under the
designation LT307.512.1.
The programming port is a standard RS 232 interface.
CAUTION ! The system port is not isolated and is not earth-free!
8 Memory Card Slot
The project data for operating the Touch Operator Panel is stored on the memory card in the memory card
slot. The project data is created on PC using the relevant design software for the configurator software. If the
PC has a PC card drive, the project data can be transferred directly to the memory card. The memory card,
in turn, is then simply fitted in the memory card slot of the device. The application can then be started up
after switching on the system power supply.
If the PC does not have a PC card drive, a direct program download on Windows 95 is possible via the COM
PORT of the MV4 unit. The program download via the COM PORT is very long. With Windows NT a
download via the COM PORT is not possible.
Refer to the MV4 documentation for further information.
The Memory Card is not supplied with the Touch Operator Panel.
MEMORY CARD SLOT
SYSTEM SLOT 0


Section of the connector panel on the device, showing the Memory Card Slot and the open System Slot 0
CAUTION ! When operating Touch Operator Panel secure the memory card
by using the card retaining device supplied!
The secure fitting of the memory card in the slot cannot be guaranteed
without the use of the retaining device, especially when the device is fitted
in the normal vertical position.
Card retaining device for the memory card slot