Device Description MV4-150-TA1, MV4-450-TA1, MV4-170-TA1, MV4-470-TA1 1-20
Moeller 07/01 AWB-C2700-1347GB
10 Communications Cards and COM SLOT
The Touch Operator Panel has one slot for a communications card (see Section 17). The link to the
automation equipment (e. g. PLC) or the fieldbus system is implemented using one of the several cards
available. Further information see part 3 and 4 of this documentation.
Safety precautions concerning electrostatic discharge (ESD) must be observed
when handling cards !
Never plug in the cards with the power supply switched on.
Only operate the communications card once it has been fully screwed into position.
Do not run any non-Moeller components in the slots.
Only original hardware from Moeller may be used.
Refer to the relevant communication card descriptions for information on protocols,
configuration, cable lengths etc.
Communications card in COM SLOT of the Touch Operator Panel
To Next Page
Loading...