Communications Card Description ZB4-601-IF1, ZB4-609-IF1 4-27
Moeller 07/01 AWB-C2700-1347GB
MATSUSHITA
PLC Type Protocol PLC Port Parameters
FP3/FP5
PG-Port PG-Port 9600 baud, 8 data bits, 1 stop bit, parity odd
DRIVER DESIGNATION (8, 1) : MATSUSHITA > FP1/3/5 (MPB.BIN)
SUPPORTED DATA TYPES : DT, R, SV, EV, X, Y
WIRING LIST
RS 422
Signal Pin Pin Signal
TxD+ 2 10 RxD+
RxD+ 3 9 TxD+
SG 5 7 SG
TxD- 7 3 RxD-
RxD- 8 2 TxD-
DTR+ 1 4 DSR+
DSR+ 4 5 DTR+
DTR- 6 12 DSR-
DSR- 9 11 DTR-
ZB4-601/609-IF1 FP3/5 PG
(9 pole male)
(15 pole male)
NOTES
• The connection to the PG port of the FP3 and FP5 is the same as for a programming device. Active
communication should be possible without any further steps.
• The PLC must be switched on and in Run status.
• An additional possibility of connecting to the FP1, FP3, and FP5 is via the AFP850 RS 232 <–> RS 422
converter (see below).
• Remember that the physical interface of the ZB4-601/609-IF1 must be adapted for this (RS 232).
RS 232
Signal Pin Pin Signal
RxD 2 3 TxD
TxD 3 2 RxD
DTR 4 6 DSR
SG 5 7 SG
DSR 6 20 DTR
4RTS
5CTS
ZB4-601/609-IF1 AFP8550
(9 pole male)
(25 pole male)
To Next Page
Loading...