1 - 4 MC40 Integrator Guide
1. Press the Power button until the Device options menu displays.
2. Touch Battery swap. The Right and Left LEDs light red.
3. Wait until the LEDs turns off.
4. Lift the battery latch.
Figure 1-2
Removing the Battery
5. Remove the battery out of the battery compartment.
Figure 1-3
Remove Battery
6. Align the replacement battery in the battery compartment.
7. Lower the battery and press down until it snaps into place.
8. Press down on the battery latch. If the battery is charged, the MC40 turns on automatically.
Resetting the MC40
There are four reset functions:
To Next Page
Loading...
