Motorola MC40 - Static IP Address

5 - 6 MC40 Integrator Guide
1. Touch > Setting > Wireless & networks.
2. Touch Wi-Fi settings.
3. In the Wi-Fi networks list, touch and hold the name of the network.
4. In the menu, touch Forget network.
5. Touch .
Static IP Address
By default, the MC40 is configured to use Dynamic Host Configuration Protocol (DHCP) to assign an Internet
protocol (IP) address when connecting to a wireless network. To configure the MC40 to connect to a network
using a static IP address:
1. Touch > Setting > Wireless & networks.
2. Touch Wi-Fi settings.
3. Touch > Advanced.
4. Touch Use static IP checkbox.
5. Touch IP address and enter an IP address for the device and then touch OK.
6. If required, touch Gateway and enter a gateway address for the device and then touch OK.
7. If required, touch Netmask and enter an netmask for the device and then touch OK.
8. If required, touch DNS 1 and enter a Domain Name System (DNS) address and then touch OK.
9. If required, touch DNS 2 and enter a DNS address and then touch OK.
10. Touch .