Getting Started 1 - 11
1. Tap Status Bar > .
2. Tap Phone radio to toggle the phone radio on and off.
3. Tap Wi-Fi to toggle the WLAN radio on and off.
4. Tap Bluetooth to toggle the Bluetooth radio on and off.
Handstrap Replacement
Removal
To remove a handstrap from the MC65:
1. If the MC65 is in suspend mode, press the red Power button to wake the device.
2. Press and hold the red Power button for approximately 5 seconds.
3. Release the Power button. The Data Capture LED lights red.
4. When the LED turns off, remove the handstrap.
Figure 1-7
Handstrap Clip Removal
5. Remove the battery.
6. Using a small flat screwdriver, push the head of the screwdriver between the handstrap pin and the bottom
of the housing as shown below.
7. Pry the handstrap and pin up and out of the handstrap mount area.
CAUTION Close all running applications prior to replacing the handstrap. The backup battery maintains data for
up to 15 minutes. If replacement takes longer than 15 minutes data may be lost.
CAUTION When removing handstrap pin, be careful not to damage handstrap mounting area.
To Next Page
Loading...
Need help?
General
