Using the MC65 2 - 19
Resetting the MC65
A reset restarts the MC65 by closing all running programs. Data saved in flash memory or a memory card is
not lost.
To perform a reset:
•
On a numeric keypad, simultaneously press the red Power button and the and keys.
•
On an alphanumeric keypad, simultaneously press the red Power button and the and keys.
Locking the MC65
The user can lock the MC65 to disable key presses and screen tap or by requiring a password to keep your
data secure. Refer to Locking the MC65 on page 9-4 for information on setting up device locking.
The lock screen displays whenever the MC65 is locked. When the MC65 is locked, you still receive
notifications of new messages, missed calls and upcoming appointments. You can also receive a call when the
MC65 is locked. The MC65 locks when a time out has occurred or you lock the MC65 manually.
To manually lock the MC65 tap the lock icon in the center of the Home screen Tile bar.
Off Data capture not enabled.
Charging/Battery Status LED
Slow Blinking Amber Main battery in MC65 is charging.
Solid Amber Main battery in MC65 is fully charged.
Fast Blinking Amber Charging error.
Off Not charging.
WAN Radio Status LED
Slow Blinking Green RF (WWAN) radio is on.
Off RF (WWAN) radio is off.
Table 2-4
LED Indications (Continued)
LED State Indication
NOTE For information about scanning/decoding, see Data Capture on page 2-22. For information about WWAN
radio status and settings, see Chapter 3, Making Calls, or refer to the MC65 Integrator Guide.
NOTE The user can make emergency calls even when the MC65 is locked.
To Next Page
Loading...
Need help?
General
