Using WLAN 4 - 7
Figure 4-11
Configure Network Authentication Window
7. In the Authentication drop-down list, select the authentication type.
8. In the Data Encryption drop-down list, select the data encryption type.
9. If WEP encryption is selected, enter an encryption key in the Network key text box.
10. Tap Next.
Figure 4-12
Configure Network Authentication Window
11. If required, select Use IEEE 802.1x network access control check box.
12. In the EAP type drop-down list box, select the EAP type.
13. Tap Finish.
More Information on WZC
For more information on Microsoft Wireless Zero Config, see the Microsoft Software Developer Network
(MSDN) at http://msdn.microsoft.com.
To Next Page
Loading...
