3 - 2 MC65 User Guide
Figure 3-1
Enterprise Dialer
2. Enter the phone number on the dialer or keypad. The number appears in the Call Line.
3. Tap the green Call Line or press .
4. Tap Cancel to cancel the call or tap Speaker to place the MC65 in speakerphone mode.
5. When the call connects, the name or number appears in the Call Line. To place the call on hold tap the
Call Line. To return to the call tap the Call Line again.
6. Tap or press to end the call.
Table 3-1 lists the Phone dialer icons that appear below the Status bar and above the Call Line. Icons vary
depending upon carrier and network.
Smart Dialing
Smart Dialing makes it easy to dial a phone number. When the user starts entering numbers or characters,
Smart Dialing automatically searches and sorts the contact entries on the SIM card, in Contacts, and the
phone numbers in Call Log (including incoming, outgoing, and missed calls). You can then select the desired
number or contact from the filtered list to dial.
Press keys on the MC65 keypad that correspond to the phone number or contact to call. The contact panel
lists contacts that match the sequence entered.
Smart Dialing starts looking for numbers or contacts that match the sequence entered.
Call Line
CDMAGSM/UMTS
NOTE If the user taps a wrong number, tap the Delete key to erase each subsequent digit. To erase the entire
number, tap and hold the Delete key.
Table 3-1
Phone Dialer Status Icons
Icon Description Icon Description
Bluetooth headset connected. Location disabled.
Call Forwarding enabled. Phone unlocked.
Phone audio muted.
ok
To Next Page
Loading...
