ioLogik E2210 User’s Manual Using ioAdmin
3-14
Delete I/O Server
Select this command to have ioAdmin remove the selected server.
Add Serial I/O Server
Select this command to manually add a server by using its Unit ID.
Restart System
Select this command to restart your ioLogik E2210 from a remote site
Reset to Default
Select this command to reset all settings, including console password, to factory default values.
Export System Config
Select this command to export the configuration of the ioLogik E2210 to a text file. It is strongly
recommended you use this method to back up your configuration after you have finished configuring the
ioLogik E2210 for your application.
Below is an example of the exported configuration file
Import System Config
Select this command to reload a configuration that was exported to a text file. You will need to restart the
ioLogik E2210 in order for the new configuration to take effect. This command may be used to restore a
configuration after loading the factory defaults, or to duplicate a configuration to multiple ioLogik
E2210’s.
To Next Page
Loading...
Need help?
General
